2500 And 3500
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Slide center bearing (1) and boot collar (2) on shaft.
- Install boot collar (2) and center bearing (1) with Installer (special tool #6448A, Installer, Bearing/Gear).
- Clean shaft splines and apply a coat of multi-purpose grease.
- Align master splines and slide front and rear half-shafts together.
- Slide slip yoke boot (1) on boot collar (2).
- Install slip yoke boot (1) clamp (2).
- Install propeller shaft in vehicle.