Coil Spring
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
All torques should be made with the full vehicle weight on the ground being supported by the tires.
- Position spring (1) and isolator on the axle and align into the spring upper pocket.
- Carefully raise the rear axle into place.
- Install the shock lower bolt and nut (2), and do not tighten.
- Remove the holding fixture for the rear axle.
- Remove the support and lower the vehicle.
- Tighten shock lower bolt and nut to specifications. Refer to TECHNICAL SPECIFICATIONS .