LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1620 (Rear Suspension - 2500 Hd) >> Shock Absorber, Suspension >> Installation >> Shock With Coil Spring

Shock With Coil Spring

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

All torques should be made with the full vehicle weight on the ground being supported by the tires.

  1. Position the top of the shock into the upper mounting bracket.
  2. Position the lower shock absorber in the bracket.
    GC0161514Courtesy of CHRYSLER GROUP, LLC
  3. Install the top bushing, washer (2) and nut (1). Do not tighten.
    GC0161635Courtesy of CHRYSLER GROUP, LLC
  4. Install the bolt and nut (2) through the bracket and the shock.
  5. Remove the holding fixture supporting the axle.
  6. Remove the support and lower the vehicle.
  7. Tighten shock bolt and nuts to specifications. Refer to TECHNICAL SPECIFICATIONS .
  8. Install the rear inner wheel house splash shield.
scientia non olet · About LEMON Manuals