Reservoir, Air Suspension: Installation
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
All pressurized air suspension components contain high pressure air (up to 220 psig). Use extreme caution when inspecting for leaks. Wear safety goggles and adequate protective clothing when inspecting or servicing the air suspension system. A sudden release of air under this amount of pressure can cause possible serious or fatal injury.
WARNING:
Before performing any service on the air suspension system, the system must be disabled to prevent the system from changing ride height. Before any given component is to be serviced it must be deflated. Servicing the air suspension system without the system disabled, or with pressure in any specific component, can cause possible serious or fatal injury.
- Slide the reservoir bracket onto the front bolt (3) then install the rear bolts (2). Tighten the reservoir bracket bolts to the proper torque specifications. Refer to TECHNICAL SPECIFICATIONS .
- Install the air connection to air reservoir (2).
- Lower the vehicle.
- Connect the negative battery cable.
- Perform the Complete System Fill procedure. Refer to STANDARD PROCEDURE .