LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1620 (Rear Suspension - 2500 Hd) >> Hose Assembly, Air Suspension >> Installation

Hose Assembly, Air Suspension: Installation

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

All pressurized air suspension components contain high pressure air (up to 220 psig). Use extreme caution when inspecting for leaks. Wear safety goggles and adequate protective clothing when inspecting or servicing the air suspension system. A sudden release of air under this amount of pressure can cause possible serious or fatal injury.

WARNING:

Before performing any service on the air suspension system, the system must be disabled to prevent the system from changing ride height. Before any given component is to be serviced it must be deflated. Servicing the air suspension system without the system disabled, or with pressure in any specific component, can cause possible serious or fatal injury.

GC0161544Courtesy of CHRYSLER GROUP, LLC
  1. Position and route the air suspension hose assembly (1) in the vehicle.
    GC0169718Courtesy of CHRYSLER GROUP, LLC
  2. Connect the hose assembly (1) to the ASU.
  3. Install the hose assembly into the routing clips (2).
  4. Lower the vehicle.