Arm, Upper Control: Installation
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The small bushing attaches to the axle and the large bushing to the frame.
- Position the upper control arm (6) to the vehicle.
- Install the upper control arm bolt (5) and nut at the frame. Do not tighten.
- Install the upper control arm bolt with a new nut (1) at the axle. Do not tighten.
- Remove the holding fixture supporting the axle.
- Remove the support and lower the vehicle.
- Tighten the upper control arm bolts/nuts to specifications. Refer to TECHNICAL SPECIFICATIONS .