Arm, Lower Control: Installation
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The small bushing attaches to the frame and the large bushing to the axle.
- Install the lower control arm to the vehicle.
- Install the lower control arm bolt (4) with a new nut at the axle. Do not tighten.
- Install the lower control arm bolt and nut (2) at the frame. Do not tighten.
- Position the parking brake cable guide (Left side only), install the guide bolt (3) and tighten to specifications. Refer to TECHNICAL SPECIFICATIONS .
- Remove the holding fixture supporting the axle.
- Remove the support and lower the vehicle.
- Tighten the lower control arm bolts to specifications. Refer to TECHNICAL SPECIFICATIONS .