Section 1619 (Rear Axle - 292 Aa (11 1/2) - 2500 Hd): Removal

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

If equipped, remove the air springs. Refer to SPRING(S), REMOVAL .
Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
Mark rear propeller shaft to pinion flange for alignment.
Remove fasteners attaching rear proper shaft to pinion flange.
CAUTION:
Do not allow the propeller shaft to hang from the vehicle unsupported. Damage may occur to the joint, boot, and center bearing from over-angulation.

CAUTION:
Failure to follow these instruction may result in a driveline vibration.
Position propeller shaft aside and support.
Disconnect rear wheel speed sensors.
If equipped, disconnect the electric locker wire harness connector.
Disconnect the hydraulic brake hoses at the axle.
Disconnect parking brake cables. Refer to CABLE, PARKING BRAKE, REMOVAL .

Courtesy of CHRYSLER GROUP, LLC
Remove stabilizer bar fasteners (2) at axle housing.
Secure rear axle housing to a suitable jack.

Courtesy of CHRYSLER GROUP, LLC
Remove fastener (1) securing track bar to rear axle housing.
If equipped, remove rear coil springs. Refer to SPRING(S), REMOVAL .

Courtesy of CHRYSLER GROUP, LLC
Remove the upper and lower control arm to axle housing fasteners (4 and 5).
NOTE:
Right side shown, left side similar.
Carefully lower axle away from vehicle.