LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1619 (Rear Axle - 292 Aa (11 1/2) - 2500 Hd) >> Bearing, Differential Side >> Removal >> With ELSD

With ELSD

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove differential case from the housing.
    GC0169741Courtesy of CHRYSLER GROUP, LLC
  2. Install Plug (special tool #8964, Plug, Differential Bearing) (2) into the end of the case.
  3. Install (special tool #2022100030, Puller Press, Carrier Bearing) (1) and (special tool #2022101030, Block Set, Carrier Bearing) (3) over bearing (4) as shown. Be sure the anti-rotation tab (5) aligns with the flats of the puller.
    GC0169731Courtesy of CHRYSLER GROUP, LLC
  4. Position the puller (2) in a suitable vise (4).
    NOTE:

    Have an assistant hold the differential case to prevent it from dropping off of the bench.

  5. Tighten the forcing screw (1) of the puller to remove the bearing.
scientia non olet · About LEMON Manuals