Diagnostic Test

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

DO NOT REPLACE TPM SENSOR. THIS FAULT IS EXPECTED IF TIRE PRESSURE IS 20% BELOW THE PLACARD PRESSURE

Inflate tire to cold placard pressure to remove the fault condition

NOTE:

It is recommended to inflate tire 2 psi past placard pressure to ensure fault condition clears.

Test drive the vehicle at a speed greater than 24 km/h (15 mph) for 5 minutes in order to receive TPM Sensor data and allow for the system to update.
1. Test complete
2. Perform the TPM VERIFICATION TEST. Refer to TPM SENSOR VERIFICATION TEST .