Diagnostic Test
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- ACTIVE DTC NOTE:
Diagnose any Communication DTCs before continuing.
- Turn the ignition on.
- With the scan tool, clear all DTCs.
- Cycle the ignition off for 30 seconds, and then back on.
- With the scan tool, select View DTCs.
Is the DTC Active or Pending at this time?
Yes
- Go To 2
No
- Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to INTERMITTENT CONDITION .
- CHECK FOR COMMUNICATION DTCS PRESENT
Are the U110F or U1411 DTCs present in the PCM?
Yes
- Diagnose and repair those DTCs.
- Perform the POWERTRAIN VERIFICATION TEST. Refer to POWERTRAIN VERIFICATION TEST .
No
- Diagnose the appropriate Fuel Level Sensor 1 Circuit DTC in the BCM. Refer to DIAGNOSTIC CODE INDEX .