Switch, Remote Radio: Removal

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of CHRYSLER GROUP, LLC

WARNING:

Disable the airbag system before attempting any steering wheel, steering column, seat belt tensioner, side airbag or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable. Wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.

Disconnect and isolate the battery negative cable.
Remove the driver airbag. Refer to AIR BAG, DRIVER, REMOVAL .
Remove the speed control switches (2). Refer to SWITCH, SPEED CONTROL, REMOVAL .
Unplug the wire harness connector from the remote radio switch (1).
Depress the tabs on each side of each switch and push the switch through the rear steering wheel cover.