Section 1610 (Audio/Video/Entertainment/Connectivity - ( Service Information ) - 2500 Hd): Radio: Removal
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative battery cable.
- Remove the center trim bezel from the instrument panel. Refer to BEZEL, INSTRUMENT PANEL, CENTER, REMOVAL
.CAUTION:
Pulling the antenna cable straight out of the radio without pulling on the locking antenna connector could damage the cable or radio.
- Remove the four fasteners (1) securing the Radio Receiver Module (RRM) (2) to the instrument panel.
- Pull the RRM out far enough to access the back of the RRM.
- Disconnect the antennas (2), and electrical connector (1).
- If equipped, disconnect the USB connector (3).
- Remove the RRM from the instrument panel.