LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1610 (Audio/Video/Entertainment/Connectivity - ( Service Information ) - 2500 Hd) >> Mast, Antenna >> Installation

Mast, Antenna: Installation

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0143943Courtesy of CHRYSLER GROUP, LLC
  1. Tie the cord that was used during the removal procedure to the cable being installed.
  2. Using the cord, pull the antenna cable through the hole in the door opening and seat grommet into place (1).
  3. Insert the antenna body through the hole in the fender and install adapter.
  4. Install and tighten the antenna cap nut (2) with the (special tool #C-4816, Socket, Antenna).
    GC0143941Courtesy of CHRYSLER GROUP, LLC
  5. Verify that the antenna grommet is fully seated (3).
  6. Connect the antenna mast connector (2) to the instrument panel antenna cable (1).
    GC0089061Courtesy of CHRYSLER GROUP, LLC
  7. Install the passenger cowl trim panel (1). Refer to PANEL, COWL TRIM, INSTALLATION .
    GC0143942Courtesy of CHRYSLER GROUP, LLC
  8. Install the antenna mast (1).
  9. Connect the battery negative cable.
scientia non olet · About LEMON Manuals