LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 161 (Wiper System & Washer System (Service Information)) >> Switch, Washer Fluid Level >> Removal >> Gasoline Engine

Gasoline Engine

WARNING: This page is about a different car, the 2012 RAM Pickup and 2012 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Washer Reservoir & Level Switch Connector
GC0087756Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the battery negative cable.
  2. Remove the windshield washer reservoir (3) from the Front End Module (FEM) carrier (also known as the radiator closure), but it is not necessary to disconnect the wiring or washer hose from the washer pump/motor unit. Refer to RESERVOIR, WINDSHIELD WASHER, REMOVAL .
  3. Rotate the outboard side of the washer reservoir away from the FEM carrier far enough to access and disconnect the FEM wire harness connector (1) from the washer fluid level switch connector receptacle (2) on the back of the reservoir.
  4. Using a trim stick or another suitable wide flat-bladed tool, gently pry the barbed nipple of the washer fluid level switch out of the rubber grommet seal in the washer reservoir. Care must be taken not to damage the reservoir.
  5. Remove the switch from the washer reservoir.
  6. Remove the rubber grommet seal from the switch mounting hole in the washer reservoir and discard.
scientia non olet · About LEMON Manuals