LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1603 (Base Brakes - (Service Information) - 2500 Hd) >> Hydraulic/Mechanical >> Tubes And Hoses, Brake >> Removal >> Rear Tube / Hose Assembly - Heavy Duty

Rear Tube / Hose Assembly - Heavy Duty

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0108023Courtesy of CHRYSLER GROUP, LLC
  1. Install prop rod on the brake pedal to keep pressure on the brake system, Holding pedal in this position will isolate master cylinder from hydraulic brake system and will not allow brake fluid to drain out of brake fluid reservoir while brake lines are open. This will allow you to bleed out the area of repair instead of the entire system.
  2. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  3. Remove the brake line located at the axle.
  4. Remove the mounting bolt (2) for the brake hose (3) at the axle.
  5. Remove the banjo bolt (1) at the caliper and discard the copper washers.
  6. Remove the hose.
scientia non olet · About LEMON Manuals