LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1603 (Base Brakes - (Service Information) - 2500 Hd) >> Hydraulic/Mechanical >> Tubes And Hoses, Brake >> Installation >> Rear Tube / Hose Assembly - Heavy Duty

Rear Tube / Hose Assembly - Heavy Duty

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0108028Courtesy of CHRYSLER GROUP, LLC
  1. Install the hose (3).
  2. Install the banjo bolt (1) and two new copper washers at the caliper and tighten fitting bolt to 27 N.m (245 in. lbs.).
  3. Install the mounting bolt (2) for the brake hose (3) at the axle.
  4. Install the brake line located at the axle.
  5. Lower the vehicle and remove the support.
  6. Remove the prop rod from the brake pedal.
  7. Bleed the area of repair for the brake system. If a proper pedal is not felt during bleeding an area of repair then a base bleed system must be performed.  . Refer to STANDARD PROCEDURE  .
scientia non olet · About LEMON Manuals