Reservoir, Brake Master Cylinder: Removal
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
All views are typical.
| 1 - MASTER CYLINDER CAP |
| 2 - FLUID RESERVOIR |
| 3 - FLUID LEVEL SWITCH |
| 4 - MASTER CYLINDER |
| 5 - MOUNTING BOLT |
| 6 - GROMMETS |
- Install the prop rod on the brake pedal to keep pressure on the brake system.
- Remove the reservoir cap (1) and siphon fluid into a drain container.
- Remove the electrical connector from the fluid level switch (3) in the reservoir (2).
- Remove the reservoir mounting bolt (5).
- Remove the reservoir (2) from the master cylinder (4) by pulling upwards.
- Remove old grommets from cylinder body.