Pedal(S), Brake And/Or Accelerator: Description
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
A suspended-type brake pedal is used. The pedal is attached to the pedal support bracket (4) with a pivot shaft pin, bushings and 2 e-clips (1, 2). If the bushings become dry a spray lubricant can be used to eliminate noises. The booster push rod is attached to the pedal with e-clips. The pedal (3), bushings/pivot pin (1, 2) and support bracket (4) are serviceable separate from the assembly and the accelerator pedal. If equipped with adjustable pedals the brake pedal is serviced with the adjustable (drive) cable (from the adjustable pedal motor). For brake pedal replacement with or without adjustable pedals, the assembly must be removed from the vehicle. Adjustable pedal components can be serviced as follows:
- Adjustable pedal assembly (including bracket and all subcomponents)
- Brake pedal assembly (including adjustment cable)
- Accelerator pedal (Electronic Throttle Control [ETC])
- Accelerator subassembly (including adjustable pedal motor, ETC, ETC mounting plate and bracket).