Pads, Brake: Installation: Rear

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of CHRYSLER GROUP, LLC

1 - CALIPER ADAPTER

2 - ANTI-RATTLE SPRING

Clean caliper mounting adapter (1) and anti-rattle springs (2).
Lubricate anti-rattle springs with Mopar brake grease.
NOTE:
Anti-rattle springs are not interchangeable.
Install new top anti-rattle spring (2).

Courtesy of CHRYSLER GROUP, LLC

1 - ANTI-RATTLE SPRING

2 - CALIPER ADAPTER
Install new bottom anti-rattle spring (1).

Courtesy of CHRYSLER GROUP, LLC

1 - INBOARD SHOE

2 - CALIPER ADAPTER
Install inboard brake shoe (1) in adapter (2).

Courtesy of CHRYSLER GROUP, LLC

1 - OUTBOARD SHOE

2 - CALIPER ADAPTER
Install outboard brake shoe (1) in adapter (2).

Courtesy of CHRYSLER GROUP, LLC
Tilt the bottom of the caliper (3) over rotor (1) and under adapter. Then push the top of the caliper down onto the adapter.

Courtesy of CHRYSLER GROUP, LLC
Install caliper (6). Refer to CALIPER, DISC BRAKE, INSTALLATION .
Install wheel and tire assemblies. Refer to TECHNICAL SPECIFICATIONS .
Remove the supports and lower the vehicle.
Apply brakes several times to seat caliper pistons and brake shoes and obtain firm pedal.
Top off master cylinder fluid level.