Switch, Brake Fluid Level: Removal

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

All views are typical.

Thoroughly clean all surfaces of brake fluid reservoir and master cylinder. Use only Mopar® Brake Parts Cleaner or equivalent.

Courtesy of CHRYSLER GROUP, LLC
Disconnect wiring harness connector (2) from brake fluid level switch (1) in master cylinder brake fluid reservoir.

Courtesy of CHRYSLER GROUP, LLC

NOTE:
A small angled hex wrench can be used to depress the switch release tab.
Depress tab (1) on bottom of reservoir, then grasp the connector end of brake fluid level switch (2) and pull it out of reservoir.