Water-To-Oil Cooler
WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Guide the oil cooler onto the studs located on the cylinder block.
- Install the upper (2) and lower nuts to cylinder block finger tight.
- Install and tighten mounting bolt (1) to cooler at cylinder block to 24 N.m (18 ft. lbs).
- Torque the nuts to 24 N.m (18 ft. lbs.)
- Install the ground cable. Install the retaining nut (6).
- Tighten lower mounting bolt to cooler at the cylinder block. Tighten to 77 N.m (57 ft. lbs.).NOTE:
Use a back-up wrench on the transmission cooler fittings to prevent damage to the cooler.
- Tighten upper mounting bolt to cooler at cylinder block to 24 N.m (18 ft. lbs).
- Install wire harness push in clip at bottom of cooler bracket.
- Install starter motor. Refer to STARTER, Installation .
- Connect battery negative cables.
- Fill cooling system. Refer to Standard Procedure .
- Check transmission oil level and fill as necessary.