3.7L/4.7L/5.7L Engine
WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - TRANSMISSION COOLER LINES |
| 2 - RADIATOR |
| 3 - QUICK CONNECT FITTINGS |
- Position the transmission cooler tubes to the front of the radiator by sliding brackets into slots on radiator inlet tank.
- Snap the transmission cooler tubes into the clips on the side of the radiator tank.
- Install the transmission cooler attaching bolt. Tighten the bolt to 16 N.m (140 in. lbs.).
- Inspect the quick connect fittings for debris and install the quick connect fitting on the cooler tube until an audible "click" is heard. Pull on the connection to verify proper installation and install the secondary latches. Refer to TUBES AND HOSES, Transmission Oil Cooler, Standard Procedure .
- Start the engine and check all fittings for leaks.
- Check the fluid level in the automatic transmission.