5.7L Engine
WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Position the thermostat and thermostat housing (3) onto the water pump.
- Install the thermostat housing (3) bolts. Tighten the bolts to 13 N.m (10 ft. lbs.).
- Install the radiator hose (1) onto the thermostat housing (3).
- Fill the cooling system. Refer to Standard Procedure .
- Connect the negative battery cable.
- Start and warm the engine. Check for leaks. Refer to Standard Procedure .