6.7L Diesel
WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Hot, pressurized coolant can cause injury by scalding. Cooling system must be partially drained before removing the coolant temperature sensor.
- Partially drain the cooling system. Refer to Standard Procedure .
- Remove the engine trim cover.
- Remove the upper EGR tube (2). Refer to TUBE, Exhaust Gas Recirculation (EGR), Crossover, Removal .
- Remove heat shield.
- Disconnect the electrical connector (2) from the ETC sensor (3).
- Remove the ETC sensor from the cylinder head.