6.7L Diesel Engine
WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - BLOCK HEATER |
- Clean and inspect the threads in the cylinder block and heater element.
- Coat heater element threads with Mopar® Thread Sealer with Teflon.
- Screw block heater (1) into cylinder block and tighten to 75 N.m (55 ft. lbs.).
- Connect block heater cord and tighten retaining cap.
- Fill cooling system with recommended coolant. Refer to Standard Procedure .
- Start and warm the engine.
- Check block heater for leaks.