5.7L Engine
WARNING: This page is about a different car, the 2011 RAM Pickup and 2011 RAM Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
When installing accessory drive belt onto pulleys, make sure that belt is properly routed and all V-grooves make proper contact with pulleys.
- Position the belt tensioner assembly (7) onto the front of the engine block. Tighten the bolt to 41 N.m (30 ft. lbs.).
- Install the accessory drive belt (4). Refer to BELT, Serpentine, Installation .