Diagnostic Test
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
STEERING WHEEL POSITION SENSOR-INTERNAL ELECTRONIC FAILURE
- Perform any Technical Service Bulletins (TSBs) that may apply.
- The ABS Module is reporting internal errors from the SAS.
- Verify that the Clockspring (SAS) is properly installed. Refer to CLOCKSPRING, STANDARD PROCEDURE
.
Were there any problems found?
Yes
- Repair as necessary.
- Perform the ABS VERIFICATION TEST. Refer to STANDARD PROCEDURE .
No
- Replace the Steering Column Control Module (SCCM) in accordance with the Service Information. Refer to MODULE, STEERING COLUMN (SCM), REMOVAL .
- Perform the ABS VERIFICATION TEST. Refer to STANDARD PROCEDURE .