LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1592 (Electronic Control Modules - (Service Information) - 2500 Hd) >> Module, Transmission Control (TCM) >> Module Programming >> Drive Learn - RFE Transmissions >> Learn The 1ST 2-3 Shift After A Restart Or Shift To Reverse

Learn The 1ST 2-3 Shift After A Restart Or Shift To Reverse

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Use the following steps to have the TCM learn the 1st 2-3 shift OD CVI.

NOTE:

The transmission oil temperature must be above 80°F (27°C).

  1. With the vehicle engine running, select reverse gear for over 2 seconds.
  2. Shift the transmission to Drive and accelerate the vehicle from a stop at a steady 15 degree throttle opening and perform a 2-3 shift while noting the 1st 2-3 OD CVI.
  3. Repeat and. Refer to  1. until the 1st 2-3 upshift becomes smooth and the 1st 2-3 OD CVI stabilizes. Refer to  2.
scientia non olet · About LEMON Manuals