LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1592 (Electronic Control Modules - (Service Information) - 2500 Hd) >> Module, Integrated Trailer Brake (ITBM) >> Installation

Module, Integrated Trailer Brake (ITBM): Installation

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the Integrated Trailer Brake Module (ITBM) and snap the bottom retainer clips into place.
    NOTE:

    One screw on the right front of the ITBM not shown.

  2. Install the ITBM retainer screws (1).
    GC0137095Courtesy of CHRYSLER GROUP, LLC
  3. Connect the ITBM electrical connectors (1).
    GC0089023Courtesy of CHRYSLER GROUP, LLC
  4. Position the left instrument panel side cover (1) and press the retainers into place in the IP. Reseat the door seal first if removed.
    GC0086792Courtesy of CHRYSLER GROUP, LLC
  5. Position the steering column opening cover (1) and press the upper retainers into place in the IP.
  6. Install the steering column opening cover retaining screws (2).
  7. Connect the battery negative cable.
scientia non olet · About LEMON Manuals