LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1592 (Electronic Control Modules - (Service Information) - 2500 Hd) >> Module, Instrument Panel Cluster >> Removal

Module, Instrument Panel Cluster: Removal

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable.
  2. Remove the cluster bezel from the instrument panel. Refer to BEZEL, INSTRUMENT CLUSTER, REMOVAL .
    GC0154533Courtesy of CHRYSLER GROUP, LLC
  3. Remove the two screws (3) that secure the instrument cluster (1) to the instrument panel (2).
    GC0154362Courtesy of CHRYSLER GROUP, LLC
  4. Pull the instrument cluster rearward far enough to access and disconnect the instrument panel wire harness connector (2) from the connector receptacles on the back of the cluster (1) housing.
  5. Remove the instrument cluster from the instrument panel.

CLUSTER LENS AND MASK 

  1. Remove the IPC.
  2. Working around the perimeter of the IPC, release the clips that secure the instrument cluster mask and lens unit to the housing.
  3. Remove the mask and lens.
scientia non olet · About LEMON Manuals