Module, Final Drive Control (FDCM): Operation: Inputs/Outputs
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
The following are inputs to the FDCM:
- Differential Locker Switch
- Rear Differential Locker Position Sensor
- Front Differential Locker Position Sensor
- Stabilizer Bar Switch
- 1 Direct Battery Feed
- Ignition RUN Sense
- Sensor Ground
- Module Ground
- CAN C Bus
The following are outputs of the FDCM:
- Differential Locker Actuators
- Sway Bar Disconnect Actuators
- Locker Status Indicators
- Sway Bar Status Indicators