Module, Final Drive Control (FDCM): Installation
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
The disconnecting stabilizer bar unit (3) is not serviced separately from the bar (4). Do not disassemble this unit from the stabilizer bar.
NOTE:
The Final Drive Control Module (FDCM) is integrated with the front stabilizer bar actuator.
- Install the actuator (1) to the disconnecting unit (3) and tighten the bolts (2) to the proper. Refer to FRONT, LINK AND COIL, TECHNICAL SPECIFICATIONS
.NOTE:
The seal must be clean and intact in the electrical connector when reconnecting to the actuator (1).
- Reconnect the electronic actuator electrical connector for the disconnecting stabilizer bar.
- Remove the supports and lower the vehicle.
- To enable a new Final Drive Control Module (FDCM)/Disconnecting Stabilizer Bar road test the vehicle until all indicator lamps stop flashing, then verify proper operation of four wheel drive and disconnecting stabilizer bar functions by actuating them electrically.