Module, Drivetrain Control (DTCM): Removal
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate the battery negative cable.
- To gain access to the Drive Train Control Module (DTCM), position the carpet that is located at the passenger side, away from the dash panel.
- Remove cover on the DTCM by pulling up on the upper rear tab (1), and rotating down and away from the module (3).
- Disconnect the module electrical connectors (2).
- Using trim stick - (special tool #C-4755, Trim Stick) or equivalent, gently pry back on the retaining tabs on the mounting plate (4) and remove module (3).