LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1592 (Electronic Control Modules - (Service Information) - 2500 Hd) >> Module, Body Control (BCM) >> Installation

Module, Body Control (BCM): Installation

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0154493Courtesy of CHRYSLER GROUP, LLC
  1. Position the BCM (2) and install the two lower and upper BCM bolts (3) to retain the BCM to the BCM bracket (1).
    GC0154501Courtesy of CHRYSLER GROUP, LLC
  2. Connect all wiring harnesses to the BCM (5).
  3. Position the park brake assembly back into place for installation. Refer to PEDAL, PARKING BRAKE, INSTALLATION .
  4. Connect the park brake switch connector.
  5. Install the left sill and cowl panel Refer to PANEL, COWL TRIM, INSTALLATION .
  6. Install the remote park release access panel.
  7. Install the amplifier. Refer to AMPLIFIER, INSTALLATION .
  8. Connect the negative battery cable.
  9. Review the RF-HUB, BCM, PCM, FOBIK and ELV REPLACEMENT AND PROGRAMMING ORDER GUIDE. Refer to STANDARD PROCEDURE .
  10. Perform the Body verification Test. Refer to BODY VERIFICATION TEST .
scientia non olet · About LEMON Manuals