Sensor, Intelligent Battery (IBS): Removal

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Do not remove the captive nut, doing so will cause the stud to break.

Courtesy of CHRYSLER GROUP, LLC

Disconnect the Intelligent Battery Sensor (IBS) wire harness connector (2).
Remove the M8 negative battery cable eyelet nut (1).

Courtesy of CHRYSLER GROUP, LLC
Remove the negative battery cable eyelet (1) and secure the negative battery cable away from the IBS negative cable terminal.

Courtesy of CHRYSLER GROUP, LLC
Loosen
the M6 battery cable clamp with IBS captive nut (1).

NOTE:
Do not remove the M6 captive nut, doing so may cause the M6 stud on the battery cable clamp with IBS to break.
Using an appropriate battery terminal puller, remove the battery cable clamp with IBS from the negative battery post.
NOTE:
Never pry on the battery cable clamp with IBS to remove it from the battery post. This may damage the IBS.