LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1590 (Battery System (Service Information) - 2500 Hd) >> Cables, Battery >> Removal >> Left Side Diesel >> Left Side Positive

Left Side Positive

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0155269Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable (3).
  2. Remove nut (7) and the wire harness (8).
  3. Remove nut (6) and the positive battery cable (9) from clamp (5).
  4. Disconnect the battery positive cable terminal clamp (5) from battery.
    GC0155362Courtesy of CHRYSLER GROUP, LLC
  5. Disconnect the wire harness retainer (3) at the Power Distribution Center (PDC).
  6. Remove nut (2) and the cable (1) from the PDC.
  7. Disconnect the battery cable retaining pushpin securing the cable to the battery tray.
    GC0108135Courtesy of CHRYSLER GROUP, LLC
  8. Raise the vehicle on a hoist. Refer to HOISTING, STANDARD PROCEDURE .
  9. Lift the terminal cap from the starter stud.
  10. Remove the nut (2) securing the B+ cable to the
  11. Disconnect starter solenoid wire harness connector (3).
  12. Lower the vehicle.
  13. Disconnect any remaining pushpin's securing the cable to the vehicle.
  14. Remove the battery positive cable from the vehicle.
scientia non olet · About LEMON Manuals