Sensor, Particulate Matter: Installation
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Install the Particulate Matter (PM) sensor (1) and tighten the to 60 N.m (44 ft. lbs.).
- Install the PM sensor module (3) and tighten the nuts (2) to 9 N.m (80 in. lbs.).
- Connect the PM sensor wire harness connector (1).
- Flip the NOx/PM sensor module bracket 180° and install the NOx/PM sensor module bracket (1) and tighten the nuts (2, 3) to 9 N.m (80 in. lbs.).
- Install the PM sensor wire harness (1) to the retainers (2).
- Install the PM sensor wire harness (3) to the retainer (2).
- Remove support and lower the vehicle.
- Connect the negative battery cable.