Tube, Exhaust Gas RECIRCULATION (EGR), Crossover: Installation
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Clean each end of EGR crossover tube (2) and its connection points of any material.
- If required, install new seals to each end of the EGR crossover tube.
- Position EGR crossover tube to engine.
- Install the bolts (1) finger tight at center bottom of EGR crossover tube.
- Tighten EGR bolts to 9 N.m (80 in. lbs.).
- Connect the negative battery cable.