Valve, Exhaust Gas RECIRCULATION (EGR), 6.7L Diesel: Removal
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate both of the negative battery cables.
- Remove the engine oil dipstick (2).
- Remove bolts (1) and the engine cover (3).
- Disconnect the EGR valve wire harness connector (1).
- Loosen clamp (1), remove clamp (3) at EGR valve.
- Remove bolt (5) at center bottom of EGR crossover tube.
- Remove bolts (1) and the EGR valve assembly (2).
- Remove crossover tube gasket (1) and clean EGR valve. Also clean end of EGR tube of any old gasket material.
- Remove two gaskets on bottom EGR valve (4). Clean bottom of EGR valve and top of its intake connection point of any old gasket material.