Valve, Exhaust Gas RECIRCULATION (EGR), 6.7L Diesel: Installation
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Install a new EGR crossover tube gasket (1).
- Install a new gasket (4) to bottom of EGR valve (2).
- Position EGR valve assembly (2) and install the four EGR valve mounting bolts (1) finger tight.
- Install clamps (3) at end of EGR crossover tube (2).
- Install bolt (5) at center bottom of EGR crossover tube finger tight.
- First tighten clamp (3) to 10 N.m. (89 in. lbs.) then tighten clamp (1) to 10 N.m. (89 in. lbs.).
- Tighten bolt (5) to 10 N.m (89 in. lbs.).
- Tighten the four EGR valve mounting bolts (1) in a cross-cross fashion to 24 N.m (18 ft. lbs.).
- Connect the EGR valve wire harness connector (1).
- Install the engine cover (3). Tighten bolts (1) to 10 N.m (89 in. lbs.).
- Install the engine oil dipstick (2).
- Connect both negative battery cables.