Valve, Exhaust Gas RECIRCULATION (EGR) Airflow Control: Installation
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Clean the mating surfaces at the top of EGR air flow control valve (5) and the bottom of air intake connection (2).
- Using a new gasket (3) install the EGR air flow control valve (5). Tighten bolts (4 and 6) to 10 N.m (89 in. lbs.).
- Install the EGR control valve heat shield (2). Tighten the fasteners to:
- Tighten the bolt (3) to 24 N.m (18 ft. lbs.).
- Tighten the nut to 9 N.m (80 in. lbs.).
- Attach the wire harness retainers (1) to the heat shield.
- Connect the EGR air flow control valve wire harness connector (2).
- Install the EGR air flow control valve inlet hose (3). Tighten clamps (1) to 14 N.m (10 ft. lbs.).
- Install the engine cover (3).
- Install the engine oil dipstick (2). Tighten bolts (1) to 10 N.m (89 in. lbs.).
- Connect both negative battery cables.