LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1587 (Emissions Control) >> Exhaust Gas RECIRCULATION, 6.7L Diesel >> Tube, Exhaust Gas RECIRCULATION (EGR), Crossover >> Removal

Tube, Exhaust Gas RECIRCULATION (EGR), Crossover: Removal

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0161582Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate both negative battery cables at batteries.
  2. Remove the engine oil dipstick (2).
  3. Remove bolts (1) and the engine cover (3).
    GC0137182Courtesy of CHRYSLER GROUP, LLC
  4. Loosen and remove two clamps (1 and 3) at ends of EGR Crossover Tube (2).
  5. Disconnect the EGR temperature sensor harness connector (4).
  6. Remove clamp mounting bolt (5) at center bottom of EGR crossover tube.
  7. Remove EGR crossover tube (2).
  8. Remove and discard gaskets at each end of tube (2).
scientia non olet · About LEMON Manuals