Solenoid, Evaporative Emissions Purge: Removal
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
The duty cycle EVAP canister purge solenoid (2) is located in the engine compartment mounted on the intake manifold.
- Carefully pull the solenoid assembly straight up from the tongue-type bracket without bending the two vapor lines.
- Disconnect electrical wiring connector (3) at solenoid.
- Disconnect vapor line quick-connect fitting (1) at solenoid.
- Disconnect the vacuum line near the throttle body.