LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1587 (Emissions Control) >> Diesel Exhaust Fluid Emissions >> Tank, Diesel Exhaust Fluid >> Installation

Tank, Diesel Exhaust Fluid: Installation

WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0155420Courtesy of CHRYSLER GROUP, LLC
  1. Position the Diesel Exhaust Fluid (DEF) tank (2) onto tank mount (1).
  2. Install the DEF tank strap (3). Tighten nut (4) to 54 N.m (40 ft. lbs.).
    GC0155409Courtesy of CHRYSLER GROUP, LLC
  3. If necessary, connect the DEF supply line (3) to DEF pump (2).
  4. If necessary, connect the DEF pump wire harness connector (3).
  5. Position the DEF Tank onto transmission jack and raise tank part way into place.
    GC0155402Courtesy of CHRYSLER GROUP, LLC
  6. Connect the DEF dosing control unit wire harness connector (2).
    GC0155465Courtesy of CHRYSLER GROUP, LLC
  7. Raise the DEF tank (2) into place.
  8. Install the left side DEF tank mounting bolts (1) and tighten to 46 N.m (34 ft. lbs.).
    GC0155438Courtesy of CHRYSLER GROUP, LLC
  9. Install the right side DEF tank mounting bolts (1) and tighten to 46 N.m (34 ft. lbs.).
  10. Remove the transmission jack.
    GC0155461Courtesy of CHRYSLER GROUP, LLC
  11. If removed, install the DEF pump cover. Tighten bolts (1) to 14 N.m (10 ft. lbs.).
    GC0155431Courtesy of CHRYSLER GROUP, LLC
  12. Connect the DEF fill tube (1) to DEF tank (2).
  13. Connect the DEF fill tube vent line (1) to fluid limit vent valve.
  14. Remove support and lower the vehicle.
  15. Fill the DEF tank with clean fresh fluid.
  16. Connect both negative battery cables.
scientia non olet · About LEMON Manuals