GEARTRAIN, Planetary: Disassembly
WARNING: This page is about a different car, the 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The 68RFE transmission does not use a number 7 thrust bearing.
| 1 - THRUST BEARING NO. 1 |
| 2 - THRUST BEARING NO. 2 |
| 3 - THRUST BEARING NO. 3 |
| 4 - THRUST BEARING NO. 4 |
| 5 - THRUST BEARING NO. 5 |
| 6 - THRUST BEARING NO. 6 |
| 8 - THRUST BEARING NO. 8 |
| 9 - THRUST BEARING NO. 9 |
| 10 - THRUST BEARING NO. 10 |
| 11 - THRUST BEARING NO. 11 |
| 12 - THRUST BEARING NO. 12 |
| 13 - OUTPUT SHAFT BEARING |
NOTE:
The number 11 thrust bearing is captured under the input planetary carrier pinion gears and is not serviceable.
| 1. SNAP RING |
| 2. NUMBER NINE BEARING |
| 3. REVERSE PLANETARY CARRIER |
| 4. THRUST BEARING NUMBER 10 |
| 5. INPUT SUN GEAR |
| 6. NUMBER 11 BEARING (CAPTURED) |
| 7. INPUT PLANETARY CARRIER |
| 8. INPUT ANNULUS GEAR |
- Remove the snap-ring (1) holding the input annulus (6) onto the input carrier (5).
- Remove the input annulus (8) from the input carrier (7).
- Remove the number 9 thrust bearing from the reverse planetary carrier (6).
- Remove the reverse planetary gear carrier (2).
- Remove the number 10 thrust bearing (3) from the input sun gear (4).
- Remove the input sun gear (4) from the input carrier (5).