LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1584 (5.7L Engine CNG - (Service Information) - 2500 Hd) >> Valve Timing >> Cover(S), Engine Timing >> Installation

Cover(S), Engine Timing: Installation

WARNING: This page is about a different car, the 2018 RAM 2500 HD and 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0081770Courtesy of CHRYSLER GROUP, LLC
  1. Clean timing chain cover and block surface.
    NOTE:

    Always install a new gasket on timing cover.

  2. Verify that the slide bushings (1) are installed in timing cover.
  3. Install cover and new gasket. Tighten fasteners to 28 N.m (250 in. lbs.).
    NOTE:

    The large lifting stud is tightened to 55 N.m (40 ft. lbs.).

    Fig 1: Oil Pan Removal/Tightening Sequence
    GC0082910Courtesy of CHRYSLER GROUP, LLC
  4. Install the oil pan. Refer to PAN, OIL, INSTALLATION  .
    GC0089586Courtesy of CHRYSLER GROUP, LLC
  5. Install the A/C compressor (2). Tighten each of the bolts to 28 N.m (21 ft. lbs.) using the following sequence:
    • Upper bolt at front of compressor.
    • Lower bolt at front of compressor.
    • Bolt at rear of compressor (1).
    GC0143968Courtesy of CHRYSLER GROUP, LLC
  6. Install crankshaft damper. Refer to DAMPER, VIBRATION, INSTALLATION  .
  7. Install accessory drive belt tensioner assembly and both idler pulleys.
    GC0087999Courtesy of CHRYSLER GROUP, LLC
  8. Install radiator lower hose (1).
  9. Install both heater hoses (2).
    GC0152078Courtesy of CHRYSLER GROUP, LLC
  10. If removed. Install the axle assembly (Refer to INSTALLATION ).
  11. Lower the vehicle.
    GC0158032Courtesy of CHRYSLER GROUP, LLC
  12. Install the generator (2). Tighten the bolts (2) to 50 N.m (37 ft. lbs.).
    GC0157446Courtesy of CHRYSLER GROUP, LLC
  13. Install the accessory drive belt.
    GC0087442Courtesy of CHRYSLER GROUP, LLC
  14. Install the upper radiator hose (1).
  15. Connect the temperature sensor (2).
    GC0088123Courtesy of CHRYSLER GROUP, LLC
  16. Install the A/C line support brace (2).
    GC0083414Courtesy of CHRYSLER GROUP, LLC
  17. Install the fan shroud.
  18. Install the fan drive assembly.
    GC0087996Courtesy of CHRYSLER GROUP, LLC
  19. Install the engine cover (1). Refer to COVER, ENGINE, INSTALLATION 
  20. Install the air cleaner assembly (2, 4). Refer to BODY, AIR CLEANER, INSTALLATION  .
  21. Fill cooling system.
  22. Refill engine oil.
  23. Connect the battery negative cable.
scientia non olet · About LEMON Manuals