LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1584 (5.7L Engine CNG - (Service Information) - 2500 Hd) >> Engine Mounting >> Insulator, Engine Mount, Rear (Transmission) >> Removal

Insulator, Engine Mount, Rear (Transmission): Removal

WARNING: This page is about a different car, the 2018 RAM 2500 HD and 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0154452Courtesy of CHRYSLER GROUP, LLC
NOTE:

4wd mount shown. 2wd mount similar.

  1. Raise the vehicle on a hoist.
  2. Remove the lower nuts (6) from the transmission mount (5).
  3. Using a suitable jack. Raise the transmission off the crossmember.
  4. Remove the bolts (3) that secure the upper transmission mount bracket (2) to the transmission.
  5. Remove the rear mount assembly from vehicle.
  6. Remove the transmission mount nuts (1) from the upper transmission mount bracket.
  7. Separate the insulator from the transmission mounting bracket.
  8. Remove the transmission mount heat shields (4).
scientia non olet · About LEMON Manuals