LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1584 (5.7L Engine CNG - (Service Information) - 2500 Hd) >> Engine Block >> Crankshaft >> Removal

Engine Block: Crankshaft: Removal

WARNING: This page is about a different car, the 2018 RAM 2500 HD and 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0088068Courtesy of CHRYSLER GROUP, LLC
  1. Remove engine. Refer to REMOVAL  .
  2. Remove the vibration damper (1) using Crankshaft Insert (special tool #8513A, Insert, Crankshaft) (2) and Puller (special tool #1023, Puller) (3). Refer to DAMPER, VIBRATION, REMOVAL  .
    Fig 1: Rear Seal Retainer Removal/Tightening Sequence
    GC0081773Courtesy of CHRYSLER GROUP, LLC
  3. Remove the rear oil seal retainer. Refer to RETAINER, CRANKSHAFT REAR OIL SEAL, REMOVAL  .
  4. Remove the oil pan. Refer to PAN, OIL, REMOVAL  .
    GC0088057Courtesy of CHRYSLER GROUP, LLC
  5. Remove the oil pump pickup (1).
  6. Remove the windage tray/oil pan gasket.
  7. Remove the timing chain cover . Refer to COVER(S), ENGINE TIMING, REMOVAL  .
    GC0088058Courtesy of CHRYSLER GROUP, LLC
  8. Remove the oil pump (1). Refer to PUMP, ENGINE OIL, REMOVAL  .
    GC0088059Courtesy of CHRYSLER GROUP, LLC
  9. Remove the timing chain (5) and sprockets (1, 3). Refer to CHAIN AND SPROCKETS, TIMING, REMOVAL  .
    GC0081782Courtesy of CHRYSLER GROUP, LLC
  10. Identify rod bearing caps before removal. Remove rod bearing caps with bearings.
    GC0092128Courtesy of CHRYSLER GROUP, LLC
  11. Identify main bearing caps (1) before removal.
    GC0081774Courtesy of CHRYSLER GROUP, LLC
  12. Remove main bearing cap bolts.
  13. Remove main bearing caps (1) and bearings one at a time.
    GC0081775Courtesy of CHRYSLER GROUP, LLC
  14. Remove the thrust washers.
  15. Remove the crankshaft out of the block.
scientia non olet · About LEMON Manuals