LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1584 (5.7L Engine CNG - (Service Information) - 2500 Hd) >> Cylinder Head >> Cover(S), Cylinder Head >> Removal

Cover(S), Cylinder Head: Removal

WARNING: This page is about a different car, the 2018 RAM 2500 HD and 2017 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
GC0139402Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable (1).

    Right side shown, left side similar.

    GC0143844Courtesy of CHRYSLER GROUP, LLC
  2. Disconnect the ignition coil electrical connectors (1).
  3. Position the electrical harness (2) aside.
  4. Remove the ignition coil retaining bolts (3) and remove the ignition coils.
    GC0080292Courtesy of CHRYSLER GROUP, LLC
  5. Using the sequence shown, remove the cylinder head cover retaining bolts.
    CAUTION:

    Do not use harsh cleaners to clean the cylinder head covers. Severe damage to covers may occur.

    GC0139403Courtesy of CHRYSLER GROUP, LLC
  6. Remove the cylinder head cover (1).
  7. Clean the sealing surface of the cylinder head (2) and cover.
NOTE:

The cylinder head cover gasket may be used again, provided no cuts, tears, or deformation have occurred.

scientia non olet · About LEMON Manuals